Views:3 Author:Site Editor Publish Time: 2020-06-03 Origin:Site
Causes and treatment methods of belt deviation of water mill wire drawing machine
When users use the equipment, they will inevitably encounter some problems, and these problems will affect the normal operation of the work. Therefore, for users of water mill wire drawing machines, there may be problems with the deviation of the belt during the work So why is there such a problem? This article will conduct a specific analysis on this issue, and hope to help everyone.
In the process of using the water mill wire drawing machine, the deviation of the belt is one of the common faults. Everyone knows that the deviation of the belt will affect the normal progress of the wire drawing work. Deviations are generally caused by the following reasons:
The first problem is the rubber wheel wear. When using the water mill wire drawing machine, if the rubber wheel is worn out, it may cause the belt to deviate. Therefore, when the user finds such a problem, it must be carefully checked. And repair in time.
The second problem is that the belt device is not properly adjusted. When using the water mill wire drawing machine, it is necessary to adjust its various parts to the appropriate position in advance, which is also a prerequisite for ensuring its good work.
The third problem is that the abrasive belt is too loose. Therefore, for this problem, users should check the situation of the abrasive belt in time and adjust it in time to reduce its impact on the water mill wire drawing machine.
Therefore, it is recommended to everyone here, if you find that the belt is out of alignment when using the water mill wire drawing machine, don't panic, analyze it according to the reasons given above, find out what kind of situation it is, and then deal with it. For example, if the rubber wheel is worn, you can repair the rubber wheel or replace the rubber wheel with a new one; if the belt is not tight enough or if the belt is not adjusted, then press the spring tight or readjust.